Description
Steer Axle Air Ride Kit For Square U-Bolts
This front axle air ride kit for Peterbilt and Freightliner help reduce the amount of wear on truck components. The LoadShare system includes air bellows, mounting hardware, brackets, and pressure control system as well as installation instructions.
- Steer Axle Air Ride Kit
- Includes:
- Air Control Panel Kit, Part # 29-050920
- Shock Mounting Kit, Part # 29-050902
- (2) Angle Brackets
- (2) Top Plates
- (2) Double Convolute Air Springs
- (2) Bottom Mounting Plate 4 Inch
- (6) Hex Head Cap Screws - 1/2 Inch UNC By 2 Inch Length
- (4) Hex Head Cap Screws - 1/2 Inch UNC By 1 Inch Length
- (16) 1/2 Inch Washers
- (6) Locknuts - 1/2 Inch UNC
- (4) Allen Head Screws 3/8 Inch UNC By 1 Inch Length
- (4) 3/8 Inch Washers
- (4) Hex Head Cap Screws 3/8 Inch UNC By 1 Inch Length
- Standard U-Bolt Spacing
- 4 Inch Leaf Spring Width
- 6-5/8 Inch Collapsed Kit Height
- Fits Models with Square U-Bolts Only
- Sold As Kit
- Aftermarket Replacement Part (Not OEM)
- Warning: Do not inflate assembly when it is unrestricted. Assembly must be restricted by suspension or other adequate structure. Do not inflate beyond 100 PSI. Improper use or over-inflation may cause assembly to burst, causing property damage and/or severe personal injury. With a load on your truck and the air springs inflated, you must have at least one inch clearance all around the air bellows. FOR BEST RIDE use only enough air pressure in the air springs to level the vehicle when viewed from the side. Inflate the air springs to maintain this height under any conditions of load. Too much air pressure in the air springs will result in a stiffer ride. Too little air pressure will allow the vehicle to bottom out and not provide the improvement in handling that is possible. To prevent possible damage, always maintain a minimum of 2 PSI in the Load-Share bellows.
