Description
Steer Axle Air Ride Kit W/O Need For Shock Brackets
The Loadshare System Comes Complete With Air Bellows, Mounting Hardware, Brackets, Pressure Control System And Installation Instructions. The Air Bellows Are Designed To Fit In The Open Space Between The Axle Centerline, Spring Package And The Bottom Of The Vehicle Frame.
* High Quality Steer Axle Air Ride Kit
* Kit Includes
- (2) Angle Brackets
- (2) Top Plates
- (2) Double Convolute Air Springs
- (2) Single Convolute Air Springs
- (2) Bottom Mounting Plate 4 Inch
- (6) Hex Head Cap Screws - 1/2 Inch UNC By 2 Inches Long
- (4) Hex Head Cap Screws - 1/2 Inch UNC By 1 Inch Long
- (16) 1/2 Inch Washers
- (6) Locknuts - 1/2 Inch UNC
- (4) Allen Head Screws 3/8 Inch UNC By 1 Inch Long
- (4) 3/8 Inch Washers
- (4) Hex Head Cap Screws 3/8 Inch UNC By 1 Inch Long
* Fits Models with Round U-Bolts Only
* Sold As Kit
* Warranty On Front Axle Air Ride Kits Against Defects In Workmanship & Material From Date Of Purchase
***High Quality Aftermarket Replacement Part (Not OEM)***
** Warning: Do not inflate assembly when it is unrestricted. Assembly must be restricted by suspension or other adequate structure. Do not inflate beyond 100 PSI. Improper use or over-inflation may cause assembly to burst, causing property damage and/or severe personal injury.
With a load on your truck and the air springs inflated, you must have at least one inch clearance all around the air bellows. FOR BEST RIDE use only enough air pressure in the air springs to level the vehicle when viewed from the side. Inflate the air springs to maintain this height under any conditions of load. Too much air pressure in the air springs will result in a stiffer ride. Too little air pressure will allow the vehicle to bottom out and not provide the improvement in handling that is possible. To prevent possible damage, always maintain a minimum of 2 PSI in the Load-Share bellows.
